Panu Kannisto

Category: Yleinen

  • Kaamos exhibition

    Huge thanks to Takehiko Nakafuji-san for hosting my solo exhibition at Gallery Niepce in Tokyo, Japan from 20th to 25th of August 2024

  • Henri Airo & Iivari Mikkonen – Hippolyte Korjaamo

    Henrin ja Iivarin näyttely Jos tällainen kohtaus esitetään jo ennen alkutekstejä, se kasvaa merkitykseltään Hippolyte Korjaamolla käsittelee kollektiivista muistamista yhden suomalaisten nykyhistoriaa muovaavan tapahtuman ja sen yhä havaittavien vaikutusten kautta. Vaikka sotiemme veteraaneja on elossa enää alle 2000, heidän muistaminen on yhä merkittävä osa suomalaisten perinteitä. Näyttely sisältää uusia valokuvia, arkistokuvia, julkaisun ja tilan jakavan…

  • Hot Rats exhibition installation

    Here’s a quick look of my past exhibition in Gallery Myymälä2 from 15.2.2024 to 25.2.2024. Thank you Ramiro, Egle, Veera and the rest of the staff

  • Hot Rats exhibition

    I will hold a photography exhibition titled Hot Rats from 15.2. to 25.2.2024 at gallery Myymälä2 in Helsinki. The exhibition will have 85 pigment prints and 3 serigraphy works based on the images taken in Tokyo during summer 2023. It will coincide with the launch of my 2nd photobook sharing the same title. I will…

  • Print hanging clips

    To keep it short, I created these small plastic clips with a screw in Solidworks, 3D-printed them on a Voron 0.2 and I was finally able to hang all my prints without frames on a concrete wall. Printing with 0.08mm layer height yields very nice threads on ABS and 40 clips without screws takes less…

  • Silk screen covers

    I’ve been teasing my next book titled Hot Rats on instagram for a while now. While the layout is 99% ready, I haven’t found a printer for it. I think I’ll just wait for the repair of the Risograph machine at the university workshop. Meanwhile I printed the covers and I’m also planning to do…

  • Silver gelatine prints on Washi paper

    I tried to do some darkroom prints on washi in order to get deeper blacks than on inkjet. My first few experiments have been failures Cutting a template for layout of 4×5 contact prints The Fomapan emulsion which I used takes hours to melt in 40°C waterbath When left to dry, I could already see…

  • Hello World

    This is the part where I will post snippets about my upcoming projects. No polish, just BTS kinda stuff